Before the creation of flower arrangement, it is necessary to maintain and trim the flower material. If not handled properly, it will easily affect the ornamental value of the work. How should that arrange flower material clip? Let’s learn more about it.
Radial flowers
Radial chrysanthemums and carnations belong to it. Each flower has a long stem and is divided into flower arrangements easily. The following three points should be paid attention to when dividing the flowers. If it is to be long, make a beautiful line between the stem and the way the flower is attached. Large flowers can be cut short. Avoid cutting into unnatural shapes, such as right-angled bends.
Linear flowers
If the flower such as gladiolus, gentian is vivid and become the flower material of linear form, when flower material is cut, can divide it into linear form flower and block flower. When cutting, you should pay attention to the cut of the stem. Do not appear in the front of the flower. How to trim the flower material ? The length of the shear must match the required length.
Tiny flowers
Babysbreath, artest flower, jasper flower and so on belong to it. In the making of flower arrangement, it plays the important role of filling the gap between flower and flower, so long or short flower is used, if cannot cut this kind of flower material cleverly, then the whole will be inferior. Therefore, it is necessary to cooperate with its length to cut, in order to do effective application.
Flowers trimmed
After cutting, flowers should be treated in time to remove disinfected branches, dead branches, cross branches, parallel branches or unnecessary thin and weak branches, and then cut about 1cm from the base for water cultivation, reserved for flower arrangement.
1. Remove the packing immediately. Because many flower materials used in packaging materials is a poor air permeability of chemical products, and packaging pressure is tight, permeability is very poor, especially in summer, easy to cause the decay of flower materials, at the same time, also affect the appearance of flower materials, so to remove the packaging in time.
2.Prune and strip off decaying branches and petals. In the transportation due to the extrusion of water can not be normal transpiration, heat generation, causing the decay of flowers and leaves, as well as the invasion of diseases and insects, if not removed in time, will shorten the flowering period.
3.Remove the thorn. In order to facilitate the sale and use of flower materials (such as rose), pay attention to the loss of flower materials stem.
4.Remove anthers. For example, when lilies are in full bloom, the stamens will release a large amount of pollen, which is easy to stick to the petals or clothes, and is not easy to remove.
5.Retrim incision. The flower material should be repurchased in time to replenish water, before soaking, to the flower material base to shear oblique mouth (45 degrees), so that flower material water absorption unobstructed.
